-
1 surface cooling
surface cooling Oberflächenkühlung fEnglish-German dictionary of Electrical Engineering and Electronics > surface cooling
-
2 surface cooling
< hvac> ■ Oberflächenkühlung f -
3 cooling surface
-
4 cooling surface
English-German dictionary of Electrical Engineering and Electronics > cooling surface
-
5 cooling surface
English-German dictionary of Architecture and Construction > cooling surface
-
6 cooling surface
<tech.gen> ■ Kühlfläche f -
7 surface liquid cooling
<hvac.food> (e.g. milk) ■ Rieselkühlung fEnglish-german technical dictionary > surface liquid cooling
-
8 wetted surface
< pps> (surfaces in contact with a fluid; e.g. inside of pipes, valves) ■ mediumberührte Oberfläche f -
9 filling
<tech.gen> ■ Auffüllen n ; Befüllung f ; Befüllen n ; Füllung f<tech.gen> (to make sth. last longer, more substantial at low cost) ■ Streckmittel n< build> ■ Schüttung f< convey> ■ Beschickung f<mvhcl.rep> (body lead) ■ Verschwemmen n< prod> ■ Schussfaden m -
10 длительный допустимый ток
- Strombelastbarkeit, f
- Dauerstrombelastbarkeit, f
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Русско-немецкий словарь нормативно-технической терминологии > длительный допустимый ток
-
11 heat sink
<tech.gen> (cooling plate; e.g. finned) ■ Kühlblech n<tech.gen> (cooling surface; e.g. on processors) ■ Kühlfläche f<el> (stress on: heat removing component; e.g. fins on electronic device) ■ Kühlkörper m ; Wärmesenke f -
12 water
* -
13 движение воздуха
движение воздуха
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
air movement
Air movements within the Earth's atmospheric circulation; also called planetary winds. Two main components are recognized: first, the latitudinal meridional component due to the Coriolis force (a deflecting motion or force discussed by G.G. de Coriolis in 1835. The rotation of the Earth causes a body moving across its surface to be deflected to the right in the N hemisphere and to the left in the S hemisphere); and secondly, the longitudinal component and the vertical movement, resulting largely from varying pressure distributions due to differential heating and cooling of the Earth's surface. (Source: WHIT)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Русско-немецкий словарь нормативно-технической терминологии > движение воздуха
-
14 приток воды
приток воды
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
inflow
1) Water other than wastewater that enters a sewer system (including sewer service connections) from sources such as, but not limited to, roof leaders, cellars drains, yard drains, area drains, drains from springs and swampy areas, manhole covers, cross connections between storm sewers and sanitary sewers, catch basins, cooling towers, storm waters, surface runoff, street wash waters, or drainage. Inflow does not include, and is distinguished from, infiltration. 2) Action of flowing in; an inflow of effluent into a river. (Source: JJK / PHC)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Русско-немецкий словарь нормативно-технической терминологии > приток воды
См. также в других словарях:
Surface reconstruction — refers to the process by which atoms at the surface of a crystal assume a different structure than that of the bulk. Surface reconstructions are important in that they help in the understanding of surface chemistry for various materials,… … Wikipedia
Cooling tower — Natural draft wet cooling hyperboloid towers at Didcot Power Station, UK … Wikipedia
Surface condenser — A surface condenser is a commonly used term for a water cooled shell and tube heat exchanger installed on the exhaust steam from a steam turbine in thermal power stations.[1][2][3] These condensers are heat exchangers which convert steam from its … Wikipedia
Cooling load temperature difference calculation method — Contents 1 CLTD/CLF/SCL Cooling Load Calculation Method 2 History 3 Application 4 Explanation of Variables … Wikipedia
cooling system — Apparatus used to keep the temperature of a structure or device from exceeding limits imposed by needs of safety and efficiency. In a mechanical transmission, the oil loses its lubricating capacity if overheated; in a hydraulic coupling or… … Universalium
Cooling pond — Not to be confused with Spent fuel pool. Mount Storm Lake is a 1,200 acres (4.9 km2) cooling pond for a power plant in Grant County, West Virginia. A cooling pond is a man made body of water primarily formed for the purpose of supplying… … Wikipedia
cooling surface — aušinamasis paviršius statusas T sritis radioelektronika atitikmenys: angl. cooling surface vok. Kühlfläche, f rus. охлаждающая поверхность, f; поверхность охлаждения, f pranc. surface de refroidissement, f; surface réfrigérante, f … Radioelektronikos terminų žodynas
surface inversion — A meteorological phenomenon in which the temperature inversion commences at the surface of the earth or the sea. Surface inversions occur mostly at night and are caused by the cooling of the air near the surface by terrestrial radiation … Aviation dictionary
surface de refroidissement — aušinamasis paviršius statusas T sritis radioelektronika atitikmenys: angl. cooling surface vok. Kühlfläche, f rus. охлаждающая поверхность, f; поверхность охлаждения, f pranc. surface de refroidissement, f; surface réfrigérante, f … Radioelektronikos terminų žodynas
surface réfrigérante — aušinamasis paviršius statusas T sritis radioelektronika atitikmenys: angl. cooling surface vok. Kühlfläche, f rus. охлаждающая поверхность, f; поверхность охлаждения, f pranc. surface de refroidissement, f; surface réfrigérante, f … Radioelektronikos terminų žodynas
Surface condenser — Condenser Con*dens er, n. 1. One who, or that which, condenses. [1913 Webster] 2. (Physic) (a) An instrument for condensing air or other elastic fluids, consisting of a cylinder having a movable piston to force the air into a receiver, and a… … The Collaborative International Dictionary of English
