-
1 DDT
ДДТ
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
DDT
A persistent organochlorine insecticide, also known as dichlorodiphenyltrichloroethane, that was introduced in the 1940s and used widely because of its persistence (meaning repeated applications were unnecessary), its low toxicity to mammals and its simplicity and cheapness of manufacture. It became dispersed all over the world and, with other organochlorines, had a disruptive effect on species high in food chains, especially on the breeding success of certain predatory birds. DDT is very stable, relatively insoluble in water, but highly soluble in fats. Health effects on humans are not clear, but it is less toxic than related compounds. It is poisonous to other vertebrates, especially fish, and is stored in the fatty tissue of animals as sublethal amounts of the less toxic DDE. Because of its effects on wildlife its use in most countries is now forbidden or strictly limited. (Source: MGH / ALL)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Немецко-русский словарь нормативно-технической терминологии > DDT
-
2 Dauerstrombelastbarkeit, f
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Немецко-русский словарь нормативно-технической терминологии > Dauerstrombelastbarkeit, f
-
3 Strombelastbarkeit, f
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Немецко-русский словарь нормативно-технической терминологии > Strombelastbarkeit, f
-
4 Schiff
корабль
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
ship
A vessel propelled by engines or sails for navigating on the water, especially a large vessel that can not be carried aboard another, as distinguished from a boat. (Source: CED)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Немецко-русский словарь нормативно-технической терминологии > Schiff
-
5 Süßstoff
подсластитель
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
sweetener
A sweetening agent, especially one that does not contain sugar. (Source: CED)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Немецко-русский словарь нормативно-технической терминологии > Süßstoff
-
6 Klippe
скала
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
cliff
A steep coastal declivity which may or may not be precipitous, the slope angle being dependent partly on the jointing, bedding and hardness of the materials from which the cliff has been formed, and partly on the erosional processes at work. Where wave attack is dominant the cliff-foot will be rapidly eroded and cliff retreat will take place, especially in unconsolidated materials such as clays, sands, etc., frequently leaving behind an abrasion platform at the foot of the cliff. (Source: WHIT)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Немецко-русский словарь нормативно-технической терминологии > Klippe
-
7 Nadelwald
хвойный лес
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
coniferous forest
A forest type characterized by cone-bearing, needle-leaved trees. They are generally, but not necessarily, evergreen and relatively shallow-rooted. Since they grow more rapidly than most broad-leaved trees, conifers are extensively planted as a source of softwood timber and pulp. They are tolerant of wide-ranging climatic conditions, of many different types of soil and of considerable differences in terrain. Thus, they are found from the polar latitudes to the tropics, on most types of soils (especially, thin acid soils) and from mountain summits to coastal environments. (Source: WHIT)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Немецко-русский словарь нормативно-технической терминологии > Nadelwald
См. также в других словарях:
not especially — 1) not very I m not especially interested in football. 2) spoken used for answering no to a question about whether you like something, want something etc. This can sound a little rude … English dictionary
not especially — (Roget s IV) modif. Syn. somewhat, to a degree, within limits; see moderately … English dictionary for students
not especially — … Useful english dictionary
not much — not a lot, not many; not especially, not in particular … English contemporary dictionary
not too- — not very, not to such a degree, not especially … English contemporary dictionary
not very — not especially, not too … English contemporary dictionary
not very bright — not especially bright, not very intelligent … English contemporary dictionary
especially — es|pe|cial|ly [ ı speʃli ] adverb *** 1. ) used when mentioning conditions that make something more relevant, important, or true: PARTICULARLY: It was a very cold house, especially in the winter. especially because/since: He did not want to upset … Usage of the words and phrases in modern English
especially — es|pe|cial|ly W1S1 [ıˈspeʃəli] adv 1.) [sentence adverb] used to emphasize that something is more important or happens more with one particular thing than with others = ↑particularly ▪ I never liked long walks, especially in winter. ▪ Art books… … Dictionary of contemporary English
especially — /I speSFli/ also specially spoken adverb 1 (sentence adverb) used to emphasize that something is more important or happens more with one particular thing than with others: Crime is growing at a rapid rate, especially in urban areas. 2 (+ adj/adv) … Longman dictionary of contemporary English
especially */*/*/ — UK [ɪˈspeʃ(ə)lɪ] / US adverb 1) used when mentioning conditions that make something more relevant, important, or true It was a very cold house, especially in winter. especially as/because/since: He did not want to upset his father, especially as… … English dictionary
