-
1 длительный допустимый ток
- courant permanent admissible, m
- courant admissible, m
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Русско-французский словарь нормативно-технической терминологии > длительный допустимый ток
-
2 концентрация населенных пунктов
концентрация населенных пунктов
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
settlement concentration
The distribution or total amount of communities, villages and houses within a specified geographic area. (Source: RHW)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Русско-французский словарь нормативно-технической терминологии > концентрация населенных пунктов
См. также в других словарях:
Specified complexity — Part of a series of articles on Intelligent design … Wikipedia
amount of substance — noun a basic physical quantity that is proportional to the number of specified particles of a substance. The specified particle may be an atom, molecule, ion, radical, electron, etc., or any specified group of such particles. The basic SI unit of …
Notional amount — The notional amount (or notional principal amount or notional value) on a financial instrument is the nominal or face amount that is used to calculate payments made on that instrument. This amount generally does not change hands and is thus… … Wikipedia
maximum amount — A constitutional or statutory provision which deprives a court of jurisdiction where the amount or value in controversy exceeds a stated amount. 20 Am J2d Cts § 154. A statutory limitation of a penalty. 36 Am J2d Forf & P § 64. A limit on the… … Ballentine's law dictionary
minimum jurisdictional amount — A constitutional or statutory limitation on jurisdiction which deprives a court of jurisdiction where the amount or value in litigation is less than a specified amount. 20 Am J2d Cts § 154 … Ballentine's law dictionary
Eating disorder not otherwise specified — Classification and external resources ICD 10 F50.9 ICD 9 307.50 Eating di … Wikipedia
Face-Amount Certificate Company — A type of investment firm that issues debt securities to its investors. These securities are called face amount certificates and are backed by security interest on assets such as real property or other securities. This is similar in nature to… … Investment dictionary
notional amount — The principal amount or face value of a derivative. Defined by the Financial Accounting Standards Board ( FASB) in FAS 133 as the number of currency units, shares, bushels, pounds or other units specified in a derivatives contract. The notional… … Financial and business terms
face-amount certificate — A debt security issued by face amount. The holder makes payments periodically to the issues, and the issuer promises to pay the purchaser the face value at maturity or the surrendered value if the security is presented by the maturity specified… … Financial and business terms
Mandatory Redemption Schedule — Specified dates when a bond issuer is required to redeem all or a portion of the outstanding issues of a bond prior to its maturity. The issuer might be required to redeem all or a portion of the bonds according to the call or prepayment… … Investment dictionary
insurance — /in shoor euhns, sherr /, n. 1. the act, system, or business of insuring property, life, one s person, etc., against loss or harm arising in specified contingencies, as fire, accident, death, disablement, or the like, in consideration of a… … Universalium
