-
1 длительный допустимый ток
- Strombelastbarkeit, f
- Dauerstrombelastbarkeit, f
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Русско-немецкий словарь нормативно-технической терминологии > длительный допустимый ток
См. также в других словарях:
state — [steɪt] noun 1. [countable usually singular] the condition that someone or something is in at a particular time: • The property market is in a poor state. • I personally think the economy is in a worse state than the Government has been admitting … Financial and business terms
State capitalism — State capitalism, in its classic meaning, is a private capitalist economy under state control. This term was often used to describe the controlled economies of the great powers in the First World War. [cite encyclopedia encyclopedia = Blackwell… … Wikipedia
State school — For US state funded universities, see State university system. For Texas residential institutions, see Texas State Schools. State schools, also known in the United States and Canada as public schools,[note 1] generally refer to primary or… … Wikipedia
run — runnable, adj. runnability, n. /run/, v., ran, run, running, n., adj. v.i. 1. to go quickly by moving the legs more rapidly than at a walk and in such a manner that for an instant in each step all or both feet are off the ground. 2. to move with… … Universalium
run — [c]/rʌn / (say run) verb (ran, run, running) –verb (i) 1. to move quickly on foot, so as to go more rapidly than in walking (in bipedal locomotion, so that for an instant in each step neither foot is on the ground). 2. to do this for exercise, as …
run — 1 /rVn/ verb past tense ran past participle run present participle running MOVE QUICKLY ON FOOT 1 (I) to move quickly on foot by moving your legs more quickly than when you are walking: I had to run to catch the bus. | Two youths were killed when … Longman dictionary of contemporary English
run — run1 W1S1 [rʌn] v past tense ran [ræn] past participle run present participle running ▬▬▬▬▬▬▬ 1¦(move quickly using your legs)¦ 2¦(race)¦ 3¦(organize/be in charge of )¦ 4¦(do something/go somewhere quickly)¦ 5¦(buses/trains etc)¦ … Dictionary of contemporary English
run — run1 [ rʌn ] (past tense ran [ ræn ] ; past participle run) verb *** ▸ 1 move quickly with legs ▸ 2 control/organize ▸ 3 machine: work ▸ 4 liquid: flow ▸ 5 try to be elected ▸ 6 vehicle: travel ▸ 7 be shown/performed ▸ 8 reach amount/rate ▸ 9… … Usage of the words and phrases in modern English
State University of New York at Oswego — (SUNY Oswego) Motto To Learn, To Search, To Serve Established 1861 Type Public Endowment … Wikipedia
Run and gun — (dt. „rennen und schießen“) ist eine Basketball Taktik, bei der der Schwerpunkt auf schnellen Wurfabschluß gelegt wird und der Gegner „überrannt“ werden soll. Inhaltsverzeichnis 1 Beschreibung 2 Anwendung 3 Referenzen 4 … Deutsch Wikipedia
State university and college — Systems in the Philippines, or also known by its acronym SUC refers to any public institutions of higher learning that were created it by an act passed by the Philippine Congress, and is fully subsidized by the national government. An SUC is also … Wikipedia
