-
1 коэффициент искажения синусоидальности кривой напряжения (тока)
- Facteur de distortion (d’une tension ou d’un courant alternative non sinusoïdal)
- facteur de distortion (d’une tension ou d’un courant alternatif non sinusoïdal)
коэффициент искажения синусоидальности кривой напряжения (тока)
Величина, равная отношению действующего значения суммы гармонических составляющих к действующему значению основной составляющей переменного напряжения (тока).
Примечание. Для целей стандартизации допускается относить к номинальному напряжению (току).
[ ГОСТ 23875-88]
коэффициент нелинейных искажений
коэффициент несинусоидальности
КНИ
Определяет веса высших гармоник переменного напряжения по отношению к основной гармонике. Чем КНИ меньше, тем ближе форма напряжения к чистой синусоиде. Например: синусоидальная форма сигнала (КНИ=0), форма сигнала отлична от синусоидальной, но искажения не заметны на глаз (КНИ<3%), отклонение формы сигнала от синусоидальной заметно на глаз (КНИ>5%), сигнал имеет трапецеидальную или ступенчатую форму (КНИ<21%), сигнал имеет прямоугольную форму (КНИ=43%)
[ http://www.radistr.ru/misc/document423.phtml]
(полный) коэффициент гармоник
—
[Я.Н.Лугинский, М.С.Фези-Жилинская, Ю.С.Кабиров. Англо-русский словарь по электротехнике и электроэнергетике, Москва]EN
total harmonic distortions
THD
RMS value of all harmonics in a waveform (excluding fundamental) divided by RMS value of fundamental. THDV refers to Voltage waveform. THDI refers to Current waveform.
[ http://www.upsonnet.com/UPS-Glossary/]total 3rd order harmonic distortion
коэффициент искажения синусоидальности, вызванный гармоническими составляющими третьего порядка
total harmonic distortion; THD
коэффициент искажения синусоидальности
общий коэффициент несинусоидальностиtotal harmonic current distortion; THDI
коэффициент искажения синусоидальности кривой тока
обшее гармоническое искажение токаtotal harmonic voltage distortion; THDV, THDU
коэффициент искажения синусоидальности кривой напряжения
обшее гармоническое искажение напряженияПараллельные тексты EN-RU
THD is the ratio of harmonic content to the fundamental and provides a general indication of the quality of a waveform.
[Schneider Electric]Коэффициент искажения синусоидальности (THD) представляет собой отношение суммы гармонических составляющих к значению основной составляющей и является основным индикатором качества формы электрического сигнала.
[Перевод Интент]
Тематики
Синонимы
- КНИ
- коэффициент гармоник
- коэффициент искажения
- коэффициент нелинейных искажений
- коэффициент несинусоидальности
- полный коэффициент гармоник
EN
- distortion factor (of a non-sinusoidal alternating voltage or current)
- THD
- total harmonic distortions
DE
FR
- facteur de distortion (d’une tension ou d’un courant alternatif non sinusoïdal)
Смотри также
55. Коэффициент искажения синусоидальности кривой напряжения (тока)
Коэффициент искажения
D. Klirrfaktor
E. Distortion factor (of a non-sinusoidal alternating voltage or current)
F. Facteur de distortion (d’une tension ou d’un courant alternative non sinusoïdal)
Величина, равная отношению действующего значения суммы гармонических составляющих к действующему значению основной составляющей переменного напряжения (тока).
Примечание. Для целей стандартизации допускается относить к номинальному напряжению (току)
Источник: ГОСТ 23875-88: Качество электрической энергии. Термины и определения оригинал документа
Русско-французский словарь нормативно-технической терминологии > коэффициент искажения синусоидальности кривой напряжения (тока)
2 преобразователь среднеквадратичных значений
преобразователь среднеквадратичных значений
-
[IEV number 313-03-09]EN
rms-sensing transducer
transducer specifically designed to respond to the rms value of the input and which is characterized by the manufacturer for use on a specified range of waveforms
[IEV number 313-03-09]FR
transducteur de valeur efficace
transducteur spécifiquement conçu pour répondre à la valeur efficace de l’entrée et qui est caractérisé par le constructeur pour utilisation avec une plage de formes d’onde spécifiée
[IEV number 313-03-09]Тематики
- измерение электр. величин в целом
EN
DE
FR
Русско-французский словарь нормативно-технической терминологии > преобразователь среднеквадратичных значений
3 включающая и отключающая способность при коротком замыкании
включающая и отключающая способность при коротком замыкании
-
[IEV number 442-05-48]EN
short-circuit (making and breaking) capacity
the alternating component of the prospective current, expressed by its rms value, which the circuit-breaker is designed to make, to carry for its opening time and to break under specified conditions
[IEV number 442-05-48]FR
pouvoir de coupure (et de fermeture) en court-circuit
composante alternative du courant présumé, exprimée en valeur efficace, que le disjoncteur, par conception, peut établir, peut supporter pendant son temps d'ouverture et peut interrompre dans des conditions spécifiées
[IEV number 442-05-48]EN
DE
FR
Русско-французский словарь нормативно-технической терминологии > включающая и отключающая способность при коротком замыкании
4 длительный допустимый ток
- courant permanent admissible, m
- courant admissible, m
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Русско-французский словарь нормативно-технической терминологии > длительный допустимый ток
См. также в других словарях:
RMS Amazon — was a wooden paddle wheel mail steamer of the Royal Mail Steam Packet Company.History Amazon was laid down on September 1 1850 at Green s shipyard, Blackwall, London and launched on June 28 1851.Loss Amazon departed from Southampton for the West… … Wikipedia
RMS Majestic (1914) — SS Bismarck , later renamed RMS Majestic , was launched in 1914 and was, at 56,551 gross tonnage, the largest ship in the world until the completion of the SS|Normandie in 1935. Originally slated to be the third and largest member of German HAPAG … Wikipedia
True RMS converter — When measuring the value of an alternating current signal it is often necessary to convert the signal into a direct current signal of equivalent value (known as the RMS, root mean square, value). This process can be quite complex (see root mean… … Wikipedia
Root mean square — In mathematics, the root mean square (abbreviated RMS or rms), also known as the quadratic mean, is a statistical measure of the magnitude of a varying quantity. It is especially useful when variates are positive and negative, e.g., sinusoids.It… … Wikipedia
Audio power — Sound measurements Sound pressure p, SPL Particle velocity v, SVL Particle displacement ξ Sound intensity I, SIL Sound power Pac Sound power level SWL Sound energy Sound energy density … Wikipedia
dBFS — Clipping of a digital waveform Decibels relative to full scale, commonly abbreviated dBFS, measures decibel amplitude levels in digital systems such as pulse code modulation which have a defined maximum available peak level. 0 dBFS is assigned to … Wikipedia
Transformer design — This page deals primarily with the design of electrical transformers. For the definition, function, and history, see Transformer.In electrical engineering, practical transformer design requires knowledge of electrical principles, materials, and… … Wikipedia
Alternating current — (green curve). The horizontal axis measures time; the vertical, current or voltage. In alternating current (AC, also ac) the movement of electric charge periodically reverses direction. In direct current (DC, also dc), the flow of electric charge … Wikipedia
Laser beam profiler — A laser beam profiler captures, displays, and records the spatial intensity profile of a laser beam at a particular plane transverse to the beam propagation path. Since there are many types of lasers ultraviolet, visible, infrared, continuous… … Wikipedia
Multimeter — A digital multimeter A multimeter or a multitester, also known as a VOM (Volt Ohm meter), is an electronic measuring instrument that combines several measurement functions in one unit. A typical multimeter may include features such as the ability … Wikipedia
Power factor — For other uses, see Power factor (pistol). The power factor of an AC electric power system is defined as the ratio of the real power flowing to the load over the apparent power in the circuit,[1][2] and is a dimensionless number between 0 and 1… … Wikipedia
Перевод: с русского на французский
с французского на русский- С французского на:
- Русский
- С русского на:
- Все языки
- Английский
- Немецкий
- Французский