-
1 Dauerstrombelastbarkeit, f
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Немецко-русский словарь нормативно-технической терминологии > Dauerstrombelastbarkeit, f
-
2 Strombelastbarkeit, f
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Немецко-русский словарь нормативно-технической терминологии > Strombelastbarkeit, f
-
3 gelöster Sauerstoff
растворенный кислород
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
dissolved oxygen
The amount of oxygen dissolved in a stream, river or lake is an indication of the degree of health of the stream and its ability to support a balanced aquatic ecosystem. The oxygen comes from the atmosphere by solution and from photosynthesis of water plants. The maximum amount of oxygen that can be held in solution in a stream is termed the saturation concentration and, as it is a function of temperature, the greater the temperature, the less the saturation amount. The discharge of an organic waste to a stream imposes an oxygen demand on the stream. If there is an excessive amount of organic matter, the oxidation of waste by microorganisms will consume oxygen more rapidly than it can be replenished. When this happens, the dissolved oxygen is depleted and results in the death of the higher forms of life. (Source: PORT)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Немецко-русский словарь нормативно-технической терминологии > gelöster Sauerstoff
-
4 Hauptrisiko
высокий уровень риска
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
major risk
The high probability that a given hazard or situation will yield a significant amount of lives lost, persons injured, damage to property, disruption of economic activity or harm to the environment; or any product of the probability of occurrence and the expected magnitude of damage beyond a maximum acceptable level. (Source: TOE / HMD)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Немецко-русский словарь нормативно-технической терминологии > Hauptrisiko
-
5 ADI-Wert
допустимая суточная норма потребления
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
acceptable daily intake
The measurement of the amount of any chemical substance that can be safely consumed by a human being in a day. Calculations are usually based on the maximum level of a substance that can be fed to animals without producing any harmful effects. This is divided by a "safety factor" to allow for the differences between animals and humans and to take account of the variation in human diets. (Source: WRIGHT)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Немецко-русский словарь нормативно-технической терминологии > ADI-Wert
См. также в других словарях:
maximum amount — index cap Burton s Legal Thesaurus. William C. Burton. 2006 … Law dictionary
maximum amount — A constitutional or statutory provision which deprives a court of jurisdiction where the amount or value in controversy exceeds a stated amount. 20 Am J2d Cts § 154. A statutory limitation of a penalty. 36 Am J2d Forf & P § 64. A limit on the… … Ballentine's law dictionary
Maximum life span — is a measure of the maximum amount of time one or more members of a population has been observed to survive between birth and death. Most living species have at least one upper limit on the number of times cells can divide. For humans, this is… … Wikipedia
Maximum tolerable period of disruption — (MTPOD) is the maximum amount of time that an enterprise s key products or services can be unavailable or undeliverable after an event that causes disruption to operations, before its stakeholders perceive unacceptable consequences. Contents 1… … Wikipedia
maximum — [[t]mæ̱ksɪməm[/t]] ♦♦♦ 1) ADJ: ADJ n You use maximum to describe an amount which is the largest that is possible, allowed, or required. Under planning law the maximum height for a fence or hedge is 2 metres... China headed the table with maximum… … English dictionary
maximum — ▪ I. maximum max‧i‧mum 1 [ˈmæksməm] adjective [only before a noun] the maximum amount, quantity etc is the largest that is possible or allowed: • The maximum cost of the plan would be $9.7 million. • The maximum rate of income tax was cut to 35… … Financial and business terms
maximum — max|i|mum1 W3S2 [ˈmæksıməm] adj [only before noun] the maximum amount, quantity, speed etc is the largest that is possible or allowed ≠ ↑minimum ▪ The car has a maximum speed of 120 mph. ▪ They made maximum use of the resources available. ▪ To… … Dictionary of contemporary English
Maximum flow problem — An example of a flow network with a maximum flow. The source is s, and the sink t. The numbers denote flow and capacity. In optimization theory, the maximum flow problem is to find a feasible flow through a single source, single sink flow network … Wikipedia
maximum*/*/ — [ˈmæksɪməm] adj I the largest in amount, size, or number that is allowed or possible Ant: minimum The maximum amount of cash you can withdraw is £500.[/ex] II noun [C] maximum */[ˈmæksɪməm] the largest number, amount, or degree that is allowed or … Dictionary for writing and speaking English
Maximum Loan Amount — Describes the maximum amount that a borrower can borrow. The maximum loan amount is based on a combination of different factors involving the specific loan program, the value of the property that secures the loan and the borrower s qualifying… … Investment dictionary
amount — noun ADJECTIVE ▪ considerable, copious amounts, enormous, huge, immense, incredible, large, massive, significant, substantial … Collocations dictionary
