-
1 прибрежные воды
прибрежные воды
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
coastal water
Coastal waters are typically characterized by a shallow continental shelf, gently sloping seaward to a continental slope, which drops relatively abruptly to the deep ocean. The proximity of coastal water to land also influences the water circulation. In the vicinity of freshwater inflows, the nearshore circulation is altered by the presence of density-driven motions. Coastal waters are under enormous environmental stress, caused by a wide range of factors including pollution and the destruction and deterioration of marine habitats. (Source: WRIGHT)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Русско-французский словарь нормативно-технической терминологии > прибрежные воды
-
2 длительный допустимый ток
- courant permanent admissible, m
- courant admissible, m
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Русско-французский словарь нормативно-технической терминологии > длительный допустимый ток
См. также в других словарях:
The Proximity Effect — álbum de estudio de Nada Surf Publicación 22 de septiembre de 1998 Género(s) indie Duración 53:02 Discográfica … Wikipedia Español
The Proximity Effect — Album par Nada Surf Sortie 22 septembre 1998 Durée 56 min 52 s Genre Rock alternatif Producteur Nada Surf … Wikipédia en Français
The Proximity Effect — Infobox Album Name = The Proximity Effect Type = Album Artist = Nada Surf Released = September 22, 1998 Recorded = Genre = Indie rock Length = Label = MarDev Producer = Fred Maher Reviews = *Allmusic Rating|3|5… … Wikipedia
Proximity effect (audio) — The proximity effect in audio refers to a change in the frequency response of a directional microphone as the sound source is brought close to the microphone. The result of the change is a disproportionate increase in the bass response of the… … Wikipedia
Proximity effect (superconductivity) — Proximity effect is a term used in the field of superconductivity to describe phenomena that occur when a superconductor (S) is placed in contact with a normal (N) non superconductor. Typically the critical temperature T {c} of the superconductor … Wikipedia
proximity — proximity, propinquity are often used almost interchangeably to denote nearness. Proximity, however, commonly implies simple and often temporary nearness in space; it may be used with reference to either persons or things found in the same… … New Dictionary of Synonyms
Proximity effect — may refer to: *Proximity effect (atomic physics) *Proximity effect (audio) * Proximity Effect (comic) *Proximity effect (electromagnetism) *Proximity effect (electron beam lithography) *Proximity effect (superconductivity) * The Proximity Effect … Wikipedia
Proximity detector — Proximity detectors are devices that use mutual capacitance between itself and a nearby human body in order to detect a person s presence. OverviewThe human body is a great capacitor (body capacitance), and the proximity detector s capacitance… … Wikipedia
Proximity problems — is a class of problems in computational geometry which involve estimation of distances between geometric objects. A subset of these problems stated in terms of points only are sometimes referred to as closest point problems[1], although the term… … Wikipedia
Proximity effect (electron beam lithography) — The proximity effect in electron beam lithography (EBL) is the phenomenon that the exposure dose distribution, and hence the developed pattern, is wider than the scanned pattern, due to the interactions of the primary beam electrons with the… … Wikipedia
The Snow Queen — ( Sneedronningen ) is a fairy tale by author Hans Christian Andersen (1805 1875). The tale was first published in 1845, and centers on the struggle between good and evil as experienced by a little boy and girl, Kay and Gerda.The story is one of… … Wikipedia
