-
1 зараженная зона
зараженная зона
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
contaminated area
Any site or region that is damaged, harmed or made unfit for use by the introduction of unwanted substances, particularly microorganisms, chemicals, toxic and radioactive materials and wastes. (Source: TOE / HMD)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Русско-французский словарь нормативно-технической терминологии > зараженная зона
-
2 длительный допустимый ток
- courant permanent admissible, m
- courant admissible, m
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Русско-французский словарь нормативно-технической терминологии > длительный допустимый ток
См. также в других словарях:
Damaged area — Повреждённый участок (напр. формной пластины) … Краткий толковый словарь по полиграфии
ion implantation damaged area — jonų implantavimo pažeista sritis statusas T sritis radioelektronika atitikmenys: angl. ion implantation damaged area vok. durch Ionenimplantation gestörter Bereich, m rus. область, нарушенная ионной имплантацией, f pranc. région défaillie par… … Radioelektronikos terminų žodynas
Area bombardment — Aerial area bombardment is the policy of indiscriminate bombing of an enemy s cities, for the purpose of destroying the enemy s means of producing military materiel, communications, government centres and civilian morale. It differs from the use… … Wikipedia
Area 51 — This article is about the U.S. Air Force installation in Nevada. For other uses, see Area 51 (disambiguation). Area 51 … Wikipedia
Area 51 (2005 video game) — Infobox VG| title = Area 51 developer = Midway Studios Austin publisher = Midway designer = engine = released = vgrelease|North America|NA|April 25, 2005 vgrelease|European Union|EU|May 27, 2005 genre = First person shooter modes = Single player … Wikipedia
Area bombing directive — Main articles: Strategic bombing during World War II, Aerial bombing of cities, and RAF Bomber Command#Strategic bombing 1942 45 An elderly woman in front of the bodies of school children in Braunschweig, G … Wikipedia
San Francisco Bay Area — Bay Area redirects here. For other uses, see Bay Area (disambiguation). Not to be confused with San Francisco Bay Area Combined Statistical Area. San Francisco Bay Area Common name: San Fran … Wikipedia
Crystal Lake Recreation Area — Crystal Lake in Angeles National Forest, Azusa, California. Photo taken in July 1998 after a rainy season following a period of El Niño. Crystal Lake Recreation Area is part of the San Gabriel River (formerly Mount Baldy) District of the Angeles… … Wikipedia
Newtown area graffiti and street art — Since the 1980s, the area around the historic inner Sydney suburb of Newtown, NSW including the suburbs of Newtown, Enmore, Erskineville, Camperdown and St Peters has had works of graffiti and street art placed on local walls.[citation needed]… … Wikipedia
Ōsaka-Kōbe metropolitan area — ▪ urban industrial agglomeration, Japan Introduction second largest urban and industrial agglomeration in Japan, located on Ōsaka Bay in west central Honshu at the eastern end of the Inland Sea. The cities of Ōsaka and Kōbe are at the centre of… … Universalium
Tokyo-Yokohama Metropolitan Area — ▪ Japan Introduction Tokyo formerly (until 1868) Edo metropolitan complex commonly called Greater Tokyo along the northern and western shores of Tokyo Bay, on the Pacific coast of the island of Honshu, central Japan. At its centre is the… … Universalium
