compressive+modulus

См. также в других словарях:

• Compressive strength — is the capacity of a material or structure to withstand axially directed pushing forces. When the limit of compressive strength is reached, materials are crushed. Concrete can be made to have high compressive strength, e.g. many concrete… …   Wikipedia

• Young's modulus — In solid mechanics, Young s modulus (E) is a measure of the stiffness of an isotropic elastic material. It is also known as the Young modulus, modulus of elasticity, elastic modulus (though Young s modulus is actually one of several elastic… …   Wikipedia

• bulk modulus — Physics. a coefficient of elasticity of a substance, expressing the ratio between a pressure that acts to change the volume of the substance and the fractional change in volume produced. [1905 10] * * * Numerical constant that describes the… …   Universalium

• bulk modulus — noun Physics the relative change in the volume of a body produced by a unit compressive or tensile stress acting uniformly over its surface …   English new terms dictionary

• Nerve guidance conduit — A nerve guidance conduit (also referred to as an artificial nerve conduit or artificial nerve graft, as opposed to an autograft) is an artificial means of guiding axonal regrowth to facilitate nerve regeneration and is one of several clinical… …   Wikipedia

• Strength of materials — Internal force lines are denser near the hole, a common stress concentration In materials science, the strength of a material is its ability to withstand an applied stress without failure. The applied stress may be tensile, compressive, or shear …   Wikipedia

• solids, mechanics of — ▪ physics Introduction       science concerned with the stressing (stress), deformation (deformation and flow), and failure of solid materials and structures.       What, then, is a solid? Any material, fluid or solid, can support normal forces.… …   Universalium

• Properties of concrete — Concrete has relatively high compressive strength, but significantly lower tensile strength, and as such is usually reinforced with materials that are strong in tension (often steel). The elasticity of concrete is relatively constant at low… …   Wikipedia

• Buckling — In engineering, buckling is a failure mode characterized by a sudden failure of a structural member subjected to high compressive stresses, where the actual compressive stress at the point of failure is less than the ultimate compressive stresses …   Wikipedia

• Deformation (engineering) — This article is about deformation in engineering. For a more rigorous treatment, see Deformation (mechanics). Compressive stress results in deformation which shortens the object but also expands it outwards. In materials science, deformation is a …   Wikipedia

• Ceramic matrix composite — Fracture surface of a fiber reinforced ceramic composed of SiC fibers and SiC matrix. The fiber pull out mechanism shown is the key to CMC properties …   Wikipedia