-
1 длительный допустимый ток
- Strombelastbarkeit, f
- Dauerstrombelastbarkeit, f
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Русско-немецкий словарь нормативно-технической терминологии > длительный допустимый ток
-
2 потребности в основных продуктах питания
потребности в основных продуктах питания
—
[ http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]EN
basic food requirement
The minimum nutriments deemed necessary for a person of a particular age, gender, physiological condition and activity level to sustain life, health and growth. (Source: PAJ)
[http://www.eionet.europa.eu/gemet/alphabetic?langcode=en]Тематики
EN
DE
FR
Русско-немецкий словарь нормативно-технической терминологии > потребности в основных продуктах питания
См. также в других словарях:
Condition of possibility — (Bedingungen der Möglichkeit) is a philosophical concept made popular by Immanuel Kant. A condition of possibility is a necessary framework for the possible appearance of a given list of entities. It is often used in contrast to the unilateral… … Wikipedia
condition — con‧di‧tion [kənˈdɪʆn] noun [countable] LAW INSURANCE something stated in a contract, agreement, or insurance policy that must be done or must be true otherwise the contract, agreement, or policy will be ended or will not remain in force: • You… … Financial and business terms
Necessary and sufficient condition — This article is about the formal terminology in logic. For causal meanings of the terms, see Causality. In logic, the words necessity and sufficiency refer to the implicational relationships between statements. The assertion that one statement is … Wikipedia
condition — conditionable, adj. /keuhn dish euhn/, n. 1. a particular mode of being of a person or thing; existing state; situation with respect to circumstances. 2. state of health: He was reported to be in critical condition. 3. fit or requisite state: to… … Universalium
condition, necessary/sufficient — If p is a necessary condition of q, then q cannot be true unless p is true. If p is a sufficient condition of q, then given that p is true, q is so as well. Thus steering well is a necessary condition of driving well, but it is not sufficient,… … Philosophy dictionary
Condition — • That which is necessary or at least conducive to the actual operation of a cause Catholic Encyclopedia. Kevin Knight. 2006. Condition Condition … Catholic encyclopedia
Necessary — may refer to: Something that is a required condition for something else to be the case, see necessary and sufficient condition. A necessary truth, something that cannot fail to be true, see logical possibility. An important task or essential… … Wikipedia
condition — noun 1 state of sth ADJECTIVE ▪ excellent, good, immaculate, mint, perfect, pristine ▪ reasonable ▪ bad … Collocations dictionary
necessary — necessariness, n. /nes euh ser ee/, adj., n., pl. necessaries. adj. 1. being essential, indispensable, or requisite: a necessary part of the motor. 2. happening or existing by necessity: a necessary change in our plans. 3. acting or proceeding… … Universalium
condition — con|di|tion1 W1S1 [kənˈdıʃən] n ▬▬▬▬▬▬▬ 1¦(situation)¦ 2¦(weather)¦ 3¦(things affecting situation)¦ 4¦(state)¦ 5¦(health/fitness)¦ 6¦(agreement/contract)¦ 7¦(for something to happen)¦ 8¦(illness)¦ 9¦(situation of group)¦ … Dictionary of contemporary English
condition — con|di|tion1 [ kən dıʃn ] noun *** 1. ) singular or uncount the physical state of something: The survey will assess the condition of thousands of bridges. in good/bad/terrible etc. condition: The house is in fairly good condition. a ) the… … Usage of the words and phrases in modern English
