-
1 длительный допустимый ток
- courant permanent admissible, m
- courant admissible, m
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Русско-французский словарь нормативно-технической терминологии > длительный допустимый ток
См. также в других словарях:
state one's case — index plead (argue a case), speak Burton s Legal Thesaurus. William C. Burton. 2006 … Law dictionary
State and Church — • The Church and the State are both perfect societies, that is to say, each essentially aiming at a common good commensurate with the need of mankind at large and ultimate in a generic kind of life, and each juridically competent to provide all… … Catholic encyclopedia
State ratifying conventions — are one of the two methods established by Article V of the United States Constitution for ratifying constitutional amendments. Ratifying conventions have only been used for the ratification of the 21st Amendment. All others have been proposed for … Wikipedia
One-state solution — Part of a series on the Israeli–Palestinian conflict and Arab–Israeli conflict Israeli–Palestinian peace process … Wikipedia
state — /steɪt / (say stayt) noun 1. the condition of a person or thing, as with respect to circumstances or attributes: a state of disrepair. 2. condition with respect to constitution, structure, form, phase, or the like: a liquid state; the larval… …
case — I n. legal action argument 1) to hear, try a case (the court will not hear this case) 2) to argue, plead a case (the lawyer argued the case skillfully) 3) to make (out), present, state; take a case (she made out a good case for her client; the… … Combinatory dictionary
State — A state is a political association with effective sovereignty over a geographic area and representing a population. These may be nation states, sub national states or multinational states. A state usually includes the set of institutions that… … Wikipedia
case — 1. n. 1 an instance of something occurring. 2 a state of affairs, hypothetical or actual. 3 a an instance of a person receiving professional guidance, e.g. from a doctor or social worker. b this person or the circumstances involved. 4 a matter… … Useful english dictionary
State cessions — The state cessions are those areas of the United States that the separate states ceded to the federal government in the late 18th and early 19th century. The cession of these lands, which for the most part lay between the Appalachian Mountains… … Wikipedia
case — I (New American Roget s College Thesaurus) n. instance, situation, plight; sheath, scabbard, holster; portfolio; suit, action, litigation; argument, proposition; box, container, carton, casket, cabinet; bag, suitcase, handbag, grip, valise. See… … English dictionary for students
case — case1 caseless, adj. caselessly, adv. /kays/, n. 1. an instance of the occurrence, existence, etc., of something: Sailing in such a storm was a case of poor judgment. 2. the actual state of things: That is not the case. 3. a question or problem… … Universalium
