-
1 длительный допустимый ток
- courant permanent admissible, m
- courant admissible, m
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Русско-французский словарь нормативно-технической терминологии > длительный допустимый ток
-
2 электрическая прочность изоляции
электрическая прочность изоляции
Испытательное напряжение, прикладываемое в специальных условиях, которое должна выдерживать изоляция устройства
[МЭК 50(151)-78]EN
dielectric strength
maximum voltage between all parts of the electric circuit and the sheath of the thermometer or, in the case of a thermometer with two or more sensing circuits, between two individual circuits which the thermometer can withstand without damage. The measurement conditions for d.c and a.c (with frequency) have to be specified.
[IEC 60751, ed. 2.0 (2008-07)]FR
rigidité diélectrique
tension maximale entre tous les composants du circuit électrique et la gaine du thermomètre ou, dans le cas d’un thermomètre possédant plusieurs circuits de capteurs, entre deux circuits individuels, que le thermomètre peut supporter sans dégradation. Les conditions de mesure pour les tensions continues et alternatives (ainsi que la fréquence) doivent être spécifiées
[IEC 60751, ed. 2.0 (2008-07)]If used in conditions of highly humidity, the dielectric strength or electric performance may be degraded.
[LS Industrial Systems]При эксплуатации (выключателя) в условиях повышенной влажности могут ухудшиться электрическая прочность изоляции и другие электрические характеристики.
[Перевод Интент]Недопустимые, нерекомендуемые
Тематики
- электротехника, основные понятия
EN
- dielectric rigidity
- dielectric strength
- dielectric withstand
- electric strength of insulation
- insulating strength
- insulator level
FR
Русско-французский словарь нормативно-технической терминологии > электрическая прочность изоляции
См. также в других словарях:
Case-control — is a type of epidemiological study design. Case control studies are used to identify factors that may contribute to a medical condition by comparing subjects who have that condition (the cases ) with patients who do not have the condition but are … Wikipedia
Case study — This article is about the method of doing research. For the teaching method, see Case method. For the method of teaching law, see Casebook method. A case study is an intensive analysis of an individual unit (e.g., a person, group, or event)… … Wikipedia
Case management — is an area of practice within several healthcare professions. Most case managers are nurses or social workers.The term case management is also used to refer to dispute resolution systems which provide court or tribunal officials with closer… … Wikipedia
case law — n: law established by judicial decisions in cases as distinguished from law created by legislation – called also decisional law; see also common law Merriam Webster’s Dictionary of Law. Merriam Webster. 1996 … Law dictionary
Individual capital — Individual capital, also known as human capital, comprises inalienable or personal traits of persons, tied to their bodies and available only through their own free will, such as skill, creativity, enterprise, courage, capacity for moral example … Wikipedia
Case modding — Case modification (commonly referred to as case modding where an individual project is referred to as a case mod) is the modification of a computer chassis (often just referred to as the case), or a video game console chassis. Modifying a… … Wikipedia
Individual Development Accounts — (IDAs) are matched savings accounts that enable people with low incomes to save money and build assets.cite web | url=http://www.cfed.org/focus.m?parentid=31 siteid=374%id=374 title=Individual Development Accounts Focus | publisher=Corporation… … Wikipedia
Case Study House — Case Study Houses Le programme des Case Study Houses est une expérience architecturale visant à construire des maisons modernes et économiques. Il se déroule sur la côte ouest des États Unis, principalement autour de Los Angeles entre 1945 et… … Wikipédia en Français
case — case1 [kās] n. [ME & OFr cas, an event < L casus, a chance, lit., falling, pp. of cadere, to fall < IE base * k̑ad , to fall > Sans s̍ad , to fall off] 1. an example, instance, or occurrence [a case of carelessness, a case of measles] 2 … English World dictionary
Case in tiers — is a model for assigning surface case to noun phrases (NPs) in a sentence. Introduced in Yip, Maling, and Jackendoff 1987, it has received at least 88 scholarly citations according to Google Scholar. The model takes its inspiration from the… … Wikipedia
Individual income tax in Singapore — forms part of two main sources of Income tax, the other being corporate taxes on companies. Payable on an annual bases, it is currently based on the progressive tax system (for local residents), with taxes ranging from 0% to 20% since Year of… … Wikipedia
