-
1 длительный допустимый ток
- Strombelastbarkeit, f
- Dauerstrombelastbarkeit, f
(длительный) допустимый ток
Максимальное значение электрического тока, который может протекать длительно по проводнику, устройству или аппарату при определенных условиях без превышения определенного значения их температуры в установившемся режиме
[ ГОСТ Р МЭК 60050-826-2009]
Этот ток обозначают IZ
[ ГОСТ Р 50571. 1-2009 ( МЭК 60364-1: 2005)]EN
(continuous) current-carrying capacity
ampacity (US)
maximum value of electric current which can be carried continuously by a conductor, a device or an apparatus, under specified conditions without its steady-state temperature exceeding a specified value
[IEV number 826-11-13]
ampacity
The current in amperes that a conductor can carry continuously under the conditions of use without exceeding its temperature rating.
[National Electrical Cod]FR
courant (permanent) admissible, m
valeur maximale du courant électrique qui peut parcourir en permanence, un conducteur, un dispositif ou un appareil, sans que sa température de régime permanent, dans des conditions données, soit supérieure à la valeur spécifiée
[IEV number 826-11-13]Ampacity, the term is defined as the maximum amount of current a cable can carry before sustaining immediate or progressive deterioration. Also described as current rating or current-carrying capacity, is the RMS electric current which a device can continuously carry while remaining within its temperature rating. The ampacity of a cable depends on:
- its insulation temperature rating;
- conductor electrical properties for current;
- frequency, in the case of alternating currents;
- ability to dissipate heat, which depends on cable geometry and its surroundings;
- ambient temperature.
Electric wires have some resistance, and electric current flowing through them causes voltage drop and power dissipation, which heats the cable. Copper or aluminum can conduct a large amount of current before melting, but long before the conductors melt, their insulation would be damaged by the heat.
The ampacity for a power cable is thus based on physical and electrical properties of the material & construction of the conductor and of its insulation, ambient temperature, and environmental conditions adjacent to the cable. Having a large overall surface area may dissipate heat well if the environment can absorb the heat.
In a long run of cable, different conditions govern, and installation regulations normally specify that the most severe condition along the run governs the cable's rating. Cables run in wet or oily locations may carry a lower temperature rating than in a dry installation. Derating is necessary for multiple circuits in close proximity. When multiple cables are near, each contributes heat to the others and diminishes the amount of cooling air that can flow past the individual cables. The overall ampacity of the insulated conductors in a bundle of more than 3 must be derated, whether in a raceway or cable. Usually the de-rating factor is tabulated in a nation's wiring regulations.
Depending on the type of insulating material, common maximum allowable temperatures at the surface of the conductor are 60, 75 and 90 degrees Celsius, often with an ambient air temperature of 30°C. In the U.S., 105°C is allowed with ambient of 40°C, for larger power cables, especially those operating at more than 2 kV. Likewise, specific insulations are rated 150, 200 or 250°C.
The allowed current in cables generally needs to be decreased (derated) when the cable is covered with fireproofing material.
For example, the United States National Electric Code, Table 310-16, specifies that up to three 8 AWG copper wires having a common insulating material (THWN) in a raceway, cable, or direct burial has an ampacity of 50 A when the ambient air is 30°C, the conductor surface temperature allowed to be 75°C. A single insulated conductor in air has 70 A rating.
Ampacity rating is normally for continuous current, and short periods of overcurrent occur without harm in most cabling systems. The acceptable magnitude and duration of overcurrent is a more complex topic than ampacity.
When designing an electrical system, one will normally need to know the current rating for the following:- Wires
- Printed Circuit Board traces, where included
- Fuses
- Circuit breakers
- All or nearly all components used
Some devices are limited by power rating, and when this power rating occurs below their current limit, it is not necessary to know the current limit to design a system. A common example of this is lightbulb holders.
[http://en.wikipedia.org/wiki/Ampacity]
Тематики
- электротехника, основные понятия
Синонимы
EN
DE
- Dauerstrombelastbarkeit, f
- Strombelastbarkeit, f
FR
- courant admissible, m
- courant permanent admissible, m
Русско-немецкий словарь нормативно-технической терминологии > длительный допустимый ток
-
2 фаза
фаза
Проводник, пучок проводников, ввод, обмотка или иной элемент многофазной системы переменного тока, являющийся токоведущим при нормальном режиме работы.
[ ГОСТ 24291-90]
фаза электрической сети
фаза
Название провода, пучка проводов, вывода, обмотки или иного элемента многофазной системы переменного тока, являющегося токоведущим при нормальной работе
[ОСТ 45.55-99]
фаза
Часть многофазной системы электрических цепей, в которой может протекать один из электрических токов многофазной системы электрических токов.
[ ГОСТ Р 52002-2003]EN
phase
the designation of any conductor, bundle of conductors, terminal, winding or any other element of a polyphase system, which is intended to be energized under normal use
[IEV number 601-03-09]FR
phase
désignation d'un conducteur, d'un faisceau de conducteurs, de bornes, d'enroulements ou de tout autre élément d'un réseau polyphasé et susceptible d'être sous tension en service normal
[IEV number 601-03-09]Тематики
- электроснабжение в целом
- электротехника, основные понятия
EN
DE
FR
15 фаза
Проводник, пучок проводников, ввод, обмотка или иной элемент многофазной системы переменного тока, являющийся токоведущим при нормальном режиме работы
601-03-09
de Aussenleiter
en phase
fr phase
Источник: ГОСТ 24291-90: Электрическая часть электростанции и электрической сети. Термины и определения оригинал документа
Русско-немецкий словарь нормативно-технической терминологии > фаза
См. также в других словарях:
Bundle conductor — In power engineering, a bundle conductor is a number of conductors in parallel.Bundle conductors are used to increase the amount of current that may be carried in a line. Due to the skin effect, ampacity of conductors is not proportional to cross … Wikipedia
Bundle — may refer to:In mathematics: * Fiber bundle, in particular in topology, a space that looks locally like a product space *Bundle (mathematics), a generalization of a fiber bundle dropping the condition of a local product structureIn medicine: *… … Wikipedia
Conductor gallop — is the high amplitude, low frequency oscillation of overhead power lines due to wind.[1] The movement of the wires occur most commonly in the vertical plane, although horizontal or rotational motion is also possible. The natural frequency mode… … Wikipedia
conductor bundle — laidų grįžtė statusas T sritis radioelektronika atitikmenys: angl. conductor bundle vok. Leiterbündel, n rus. пучок проводов, m pranc. faisceau de conducteurs, m … Radioelektronikos terminų žodynas
Electrical conductor — Overhead conductors carry electric power from generating stations to customers. In physics and electrical engineering, a conductor is a material which contains movable electric charges. In metallic conductors such as copper or aluminum, the… … Wikipedia
Overhead power line — This article is about power lines for general transmission of electrical power. For overhead lines used to power road and rail vehicles, see Overhead lines. Transmission lines in Lund, Sweden … Wikipedia
Traction power network — articleissues original research=August 2008 POV=August 2008 refimprove=May 2007A traction power network is an electricity grid for the supply of electrified railroads. The installation of separate traction power network generally is only done if… … Wikipedia
многожильный провод — — [Я.Н.Лугинский, М.С.Фези Жилинская, Ю.С.Кабиров. Англо русский словарь по электротехнике и электроэнергетике, Москва] Тематики электротехника, основные понятия EN cablebundle conductorbundled conductormultistranded conductormultiwire… … Справочник технического переводчика
расщеплённая фаза — — [Я.Н.Лугинский, М.С.Фези Жилинская, Ю.С.Кабиров. Англо русский словарь по электротехнике и электроэнергетике, Москва, 1999 г.] Тематики электротехника, основные понятия EN bundle conductorbundled conductorsplit phase … Справочник технического переводчика
Cobranet — is a combination of software, hardware and network protocols designed to deliver uncompressed, multi channel, low latency digital audio over a standard Ethernet network. Developed in the 1990s, CobraNet is widely regarded as the first… … Wikipedia
CobraNet — logo Manufacturer Info Manufacturer Cirrus Logic … Wikipedia
